Two sizes of laser cut crossbuck cardstock adhesive backed freight doors are featured on this sheet. Just the item to dress out your scratch built or kit bashed warehouse. Four 8' wide doors and Five 6' wide doors. All doors 8' tall.
To use these doors it's recommended to paint them while they are still attached to the carrier sheet. After they have dried cut both the scribed backing piece and the crossbuck frame piece free from the carrier sheet. There are small tabs along the edges holding them to the carrier sheet. Proceed to carefully remove the protective backing sheet from the back of the crossbuck frame then align it with the front of the scribed piece and laminate the two together. If you want your doors to be open and show crossbucks on both sides then make up to single sided doors and then remove the protective backing sheet from both and laminated them back to back. Otherwise leave the protective backing sheet on the back of the assembled door.
NOTE ON MATERIALS: Only available in RCBOARD.
NOTE: This scale is normally used for Museum dioramas but is also good for perspective compression in HO scale. Placing items of this scale towards the back of the layout tends to give the impression of depth that might not be there.
